Dual Action Gravity-Feed 20cc and 40cc Airbrush

Model: X-131

· Interchangeable nozzles: Switch between 0.2mm, 0.3mm and 0.5mm nozzles, caps, and needles to adjust from fine hairline patterns to 1.75” wide spray patterns.

· Advanced control: The dual-action (trigger independently controls release of both air and fluid; pressing trigger releases air, pulling back releases material), internal-mix airbrush has a tight tolerance to create razor -sharp detail.

· Easy-to-use: This multi-purpose airbrush is designed for both the beginner and advanced user. It can be used for models, crafts, auto & cycle graphics, taxidermy, photo retouching, t-shirts, murals, fine art & illustrations and more.

Parameters

Material: Copper

Switching Mode: Dual-Action

Nozzle Dia : Airbrush on 0.2, parts 0.3 and 0.5.

Standard Nozzle Dia : 0.2 mm.

Cup Capacity: 20cc and 40cc

Working Pressure:15-50 psi

Problems:Could not spray or bad atomization.

Possible reason: nozzle clogged.

Solutions: clean the nozzle by solvent.

Possible reason: the needle chucking net is loose.

Solutions: Open the Standard-Handle Adjusting, loosen the needle chucking net; pull out the needle and put it back,repeat this action a few times ;screw tightly the needle chucking.

Question:

Can this be used for tanning

Answer:

I would imagine so but I would make sure the 0.5 tip was installed and the tanning medium was reduced properly.

Hot Tags: pro new design 0.3mm airbrush with 2 plastic cups (x-131), China, suppliers, manufacturers, factory